In the latest instalment of her series on double handed sailing skills, Pip Hare explains the best processes for handling symmetric spinnakersRotate the spinnaker to behind the jib and mainsail so it is to leeward and blanketed by them. Photo: Richard Langdon\/Pip Hare Ocean RacingDouble handed sailing skills are increasingly important to master as the recent boom in double handed racing, both inshore and offshore, continues and boats designed for couples to cruise two-up become ever more popular. We now regularly see crews of two managing all sizes of boat, and sailing them with the same efficiency and expectations as full crews.
\nThese techniques are designed for double handed crews sailing a yacht with an autopilot, and an asymmetric spinnaker. We\u2019re sailing a\u00a0J\/99, which has a fixed bowsprit and hanked-on jib. Thanks to\u00a0Key Yachting\u00a0for their support.
\nMany new designs now favour asymmetric spinnakers for downwind sailing and we\u2019ve covered those techniques in earlier articles (see yachtingworld.com\/tag\/double-handed). However, the symmetrical spinnaker still has its place in both the cruising and racing worlds and for many boats will give better downwind VMG performance than the asymmetric alternative.
\nLearning to manage this type of sail as a double-handed crew is a very attainable skill and should not be considered risky. We\u2019ll break down the key components to managing a symmetrical spinnaker, starting with hoisting and dropping in this article and moving on to gybing in next month\u2019s issue.
\nIf setting a symmetric double-handed you\u2019ll need one crew on the mast\/foredeck and another in the cockpit, with the autopilot steering. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nCrew positions
\nFor both hoists and drops you\u2019ll need one crew in the cockpit managing lines while the other is on deck managing the sail. The autopilot should steer throughout these manoeuvres, and it\u2019s well worth investing in a remote control to allow steering adjustments from any position on the boat. For both the hoist and drops, set the pilot to steer to a true wind angle. This should be deep, to reduce the apparent wind and provide shelter under which to launch the spinnaker.
\nThe Hoist
\nSet the pilot to steer a wind angle of around 160\u00b0 true, or a little higher in lighter airs to stop the boom from falling into the boat. Leave the jib up throughout the hoist. It should be over-trimmed from a downwind sailing position, with the foot just inside the guardrails, leaving enough room for the spinnaker to pass between the sail and the wires without getting trapped. Check the head of the jib is not twisted off to leeward as the spinnaker can get tangled in the leech while hoisting. To eliminate twist, either sheet on or pull the jib car forward.
\nPlug the spinnaker in well forward so the tack doesn\u2019t have far to travel to the end of the pole. Sneak a little of the clew out. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nClip the spinnaker bag on behind the jib, then check sheets and guys to leeward will run free, while those to windward are through or over the spinnaker pole. With the spinnaker bag firmly closed, set the spinnaker pole to the correct height and lock it off, you may need to help the guy through the end of the pole. At this stage, the crew in the cockpit should set the downhaul, pulling it on to a position which will allow the pole back to mid deck level but no further \u2013 the foredeck crew can always hold the pole in position to test this setting.
\nWhile the pole is being prepared the cockpit should be set to hoist: load the windward guy onto a primary winch, make sure the halyard jammer is closed, tweakers are off, the leeward guy is free to run and the leeward sheet loosely loaded on a winch. There\u2019s a lot to do in the cockpit, it must be done in sequence and ensuring your working area is snag free will help.
\nHoist the pole and pull the guy to the end of the pole. In windier conditions keep the pole well forward to the forestay. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nOnce the pole is set, pull the guy on to bring the spinnaker tack to the end of the pole. Watch the spinnaker bag \u2013 you may need to loosen the forward strap and help the guy out but don\u2019t let the bulk of the sail pull out early. Wooling or zipping the leading edge of the spinnaker will help stop an early launch. Pull on the guy until you can see the tack has reached the forestay. For a safer launch, leave the pole at the forestay, which will keep the bulk of the spinnaker in the shadow of the jib. To get the sail filling earlier, bring the pole aft \u2013 this is only advised in lighter winds and once you\u2019ve had a bit of practice.
\nOnce the tack is set, pull the halyard. The foredeck crew will need to open all bag straps then move quickly to the mast and hoist. The aim is to hoist the spinnaker to full height before it fills. I achieve this by ensuring the spinnaker sheet is set with enough slack to allow the sail to flap; do this by either locking the sheet off to a known mark which you use for every hoist, or by taking two loose turns around your trimming winch which will provide just enough friction to allow the sheet to pull gently out, but not run free.
\nHoist the spinnaker to full height, then sheet on just enough to fill it before swiftly dropping the jib. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nIf the sail does fill before hitting the top, ease the guy forward to the forestay but no further, ease the sheet, bear away gently in increments of 5\u00b0 and this should depower the sail. Try to continue the hoist in time with the boat. As it rolls, or as the sail flaps, pull the halyard up. For best results don\u2019t resort to the winch unless you are at over three-quarters hoist.
\nOnce the spinnaker is hoisted, sheet on, pull the pole back and then drop the jib, remembering to collect the spinnaker bag on your way back to the cockpit.
\nPrepare for the drop by flaking windward guy and spinnaker sheets, then ease the guy forward so pole goes to the forestay. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nDouble-handed drops
\nAs ever, preparation is key. Hoist the jib and sheet it to just inboard of the guardrails. One crew will be sitting on the side deck or in the companionway ready to gather the sail, the other is in the cockpit managing lines. All lines need to run smoothly and you cannot spend enough time preparing the cockpit. Check all windward lines will run, including the lazy sheet as well as the guy. Make sure the halyard is out from below decks or under your feet.
\nThe overview of this technique is to first drop the spinnaker into the shadow of the jib, then let the windward corner go, gather the foot of the sail in under the boom, then ease the halyard in time with the sail collection and pass the spinnaker directly down the companionway.
\nRotate the spinnaker to behind the jib and mainsail so it is to leeward and blanketed by them. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nGathering in
\nSet the autopilot to steer at a deep wind angle \u2013 this could be as low as 170\u00b0 true, so long as there is enough wind strength to keep the boom outboard. In lighter winds, sail a little higher. Position one crew on the side deck or in the companionway ready to gather the spinnaker, they will have the lazy guy in their hands, to pull the spinnaker towards them.
\nOnce lines are ready to run, ease the working guy gently forward to the forestay \u2013 beware that in bigger breeze this may result in an initial power up of the spinnaker causing the boat to roll as the centre of effort of the sail goes up. However, the spinnaker should then deflate behind the jib.
\nOnce the pole is at the forestay let the guy and windward sheet run \u2013 it\u2019s a good idea to remove stopper knots \u2013 this will allow the spinnaker to fully depower and \u2018flag\u2019 from the leeward corner.
\nEase the halyard and drop the sail directly down the companionway, gathering the foot under the boom first. Photo: Richard Langdon\/Pip Hare Ocean Racing
\nWhen the spinnaker is flapping, pull the lazy guy until the clew is in your hands, then gather the foot of the sail. For smaller spinnakers you may need to make a small ease on the halyard to get all the foot in. I do this by pre-setting 1m-1.5m of slack between the jammer and the halyard winch. When I open the jammer the sail will drop to its new position made off on the winch.
\nOnce the foot is gathered into one, lower the halyard in time with the pace at which you can drop it below. After initial stages the halyard will need less control and can be left with one or two turns on the winch to provide friction, while both crewmembers manage the spinnaker.
\nKeep an eye out for snags and make sure the leeward sheet gets released during the drop sequence. As soon as the spinnaker is under control below decks, drop the pole gently to the foredeck and take your time to get all lines back to where they should be. Even when racing it can be more expedient for a double-handed crew to keep the bow pointing downwind while the spinnaker aftermath is tidied away. Providing a more stable, drier platform allows the work to be done more quickly and with fewer errors.<\/p>\n
If you enjoyed this\u2026.<\/p>\n
Yachting World is the world\u2019s leading magazine for bluewater cruisers and offshore sailors. Every month we have inspirational adventures and practical features to help you realise your sailing dreams.<\/p>\n
Build your knowledge with a subscription delivered to your door. See our latest offers and save at least 30% off the cover price.<\/p>\n
The post Double handed sailing skills: handling symmetric spinnakers appeared first on Yachting World.<\/p>\n","protected":false},"excerpt":{"rendered":"
In the latest instalment of her series on double handed sailing skills, Pip Hare explains the best processes for handling symmetric spinnakersRotate the spinnaker to behind the jib and mainsail so it is to leeward and blanketed by them. Photo: … <\/p>\n